Article on other languages:
 |
del.icio.us |
 |
Digg |
 |
Furl |
 |
|
 |
Rojo |
| Add to OnlyWire |
An attenuator is an electronic device that reduces the amplitude or power of a signal without appreciably distorting its waveform.
An attenuator is effectively the opposite of an amplifier, though the two work by different methods. While an amplifier provides gain, an attenuator provides loss, or gain less than 1.
Attenuators are usually passive devices made from simple voltage divider networks. Switching between different resistances forms adjustable stepped attenuators and continuously adjustable ones using potentiometers. For higher frequencies precisely matched low VSWR resistance networks are used.
Fixed attenuators in circuits are used to lower voltage, dissipate power, and to improve impedance matching. In measuring signals, attenuator pads or adaptors are used to lower the amplitude of the signal a known amount to enable measurements, or to protect the measuring device from signal levels that might damage it. Attenuators are also used to 'match' impedances by lowering apparent SWR.
Power attenuators are used as loads for dissipating power while allowing the small output to be used for measurement or other purposes.
Contents |
Attenuator characteristics
Key specifications for attenuators are: [1]
- Attenuation expressed in decibels of relative power. As a rule of thumb 3dB pad halves power, 6dB quarters, 10dB is tenth, 20dB is 100th, 30dB one in one thousend and so on. For voltage you double the dBs so for example 6dB is half in voltage.
- Frequency bandwidth, for example DC-18GHz
- Power dissipation depends on mass and surface area of resistance material as well as possible additional cooling fins.
- SWR is the standing wave ratio for input and output ports
- Accuracy
- Repeatability
RF attenuators
Radio frequency attenuators are typically coaxial in structure with precision connectors as ports and coaxial, microstrip or thin-film internal structure. Above SHF special waveguide structure is required.
Important characteristics are:
- accuracy,
- low SWR,
- flat frequency-response and
- repeatability.
The size and shape of the attenuator depends on its ability to dissipate power. RF attenuators are used as loads for and as known attenuations and protective dissipations of power in measuring RF signals.
Audio attenuators
A line-level attenuator in the preamp or a power attenuator after the power amplifier uses electrical resistance to reduce the amplitude of the signal that reaches the speaker, reducing the volume of the output. A line-level attenuator has lower power handling, such as a 1/2-watt potentiometer. A power attenuator has higher power handling, such as 10 or 50 watts.
